This is especially true if you tend to move the equipment in your shop regularly. Occasionally you should inspect the cabling for frayed wiring and insure that all connections are tight. Never assume that the voltages inside the controller are not harmful. Always disconnect the equipment from the power source first. As long as you can gain access easily without disturbing any of the electronic components, you can blowout the control unit with a little compressed air (no high pressure). Most electronics maintenance is limited to cleaning the air filter and blowing the dust out of the unit. Here's a sample of the typical work that you can perform: The things you can do and should do are the basic preventive maintenance as prescribed by the manufacturer. Even if you have the skills, the documentation that the hardware manufacturer can provide is generally limited to the basics, and no hardware manufacturer wants to give away their design secrets by giving you all of their schematics. Training an engraving equipment operator with limited electrical or mechanical skills to pull serious maintenance is difficult if not impossible. It's simply easier to do it at the factory. It's not that they want to make lots of money servicing your system, or make service a difficult part of running your business. The first rule of thumb most equipment manufacturers will preach is "never do anything more than preventive maintenance on your own". Given the variety and possible configurations of systems on the market, only generalizations can be made here, and it's recommended that you obtain the proper maintenance instructions from the equipment manufacturer. Most engraving systems fall into two basic designs: a fully self-contained system where the mechanical and electrical components are in the same chassis, or a system where the engraving table and electronics controller are separated.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |